Purging Clams in Salt Water

How a salt water purge works, the salt to water ratio to mix, and how to hold live clams so sand and grit come out before cooking.

3 min read0 views
— · 0 votes
Contents
  1. Mixing the salt water ratio
  2. How the purge removes grit
  3. Holding clams during the soak
  4. Salt Water Purge Questions
  5. What is the right salt to water ratio for purging clams?
  6. How long should clams sit in salt water?
  7. Can I use table salt instead of sea salt?
  8. Do clams need to be purged before cooking?

Purging clams in salt water means holding live clams in cool salted water so they filter out sand and grit before cooking. The mix should taste like seawater, roughly a strong pinch of sea salt for each cup of water, and the clams need cool, dark, quiet conditions to open and flush. This page gives the salt to water ratio, explains how the purge works, and shows how to judge when the clams are clean and ready.

Mixing the salt water ratio

A salt water purge depends on a salt to water ratio strong enough to taste like the sea, not like soup. Mix about one tablespoon of sea salt into each quart of cool water, then stir until no crystals remain. Taste the water before adding clams, because a mix that is too weak slows the purge and a mix that is too strong stresses the shellfish. Keep the salt plain and free of iodine or anti-caking additives, since those do not belong in the water the clams will filter.

How the purge removes grit

A live clam pulls water through its body to feed, and that pumping carries loose sand and grit out of the shell. The salt water purge works because the clam keeps pumping while it sits in water it recognizes as seawater. Clams that are dead, cracked or gaping will not pump, so sort them out before the soak begins. Sand and grit removal is then a matter of time and calm conditions rather than force.

Holding clams during the soak

Clam holding time in a salt water purge is best kept short, because the animals weaken in still water as they use up oxygen. Set the container in a cool, dark place, keep the water shallow enough for the shells to sit above the surface, and change the water once or twice during the soak. Do not crowd the container, and do not leave the clams in direct sun. A pinch of cornmeal can be added to the water, though plain salted water is enough for most purges.

Salt Water Purge Questions

What is the right salt to water ratio for purging clams?

The salt to water ratio for purging clams is about one tablespoon of sea salt per quart of cool water. Mix it until the crystals dissolve fully and taste the water, which should be as salty as the ocean. A weaker mix slows the purge, while a much stronger mix stresses the clams before cooking.

How long should clams sit in salt water?

Clams sit in salt water for a short soak, generally a few hours, with the water changed partway through. Longer soaks in still water tire the animals, so watch for shells that stop responding. Purging works while the clam stays alive and pumping, so keep the soak cool and shaded.

Can I use table salt instead of sea salt?

Sea salt is the better choice for a purge because it dissolves into plain salty water without additives. Table salt often carries iodine and anti-caking agents that the clams filter along with the water. If only table salt is on hand, use it sparingly and taste the mix before adding the clams.

Do clams need to be purged before cooking?

Clams benefit from a salt water purge before cooking because the soak lifts sand and grit out of the shell. A short soak in salted water makes the meat cleaner to eat, especially for clams served in their liquor. Clams from clean, sandy beds may need only a brief rinse, while gritty ones deserve the full soak.

Latest articles