Preparing Clams for Steaming

Learn how to prepare clams for steaming: purging live clams in salt water, the cornmeal soak, scrubbing shells, and sorting out dead or open clams.

8 min read0 views
— · 0 votes
Contents
  1. Why clams need purging before steaming
  2. Setting up the salt water soak
  3. How long to soak steamer clams
  4. Sorting live clams from dead ones
  5. Scrubbing shells and rinsing
  6. A step by step routine for preparing clams
  7. Steaming clams after the soak
  8. Storage and handling notes
  9. Questions about preparing clams for steaming
  10. What do you soak clams in before steaming?
  11. How do you prepare clams for steaming step by step?
  12. Does soaking clams in salt water get rid of sand?
  13. Should you add cornmeal when soaking steamer clams?
  14. How do you know a clam is alive before cooking?
  15. What happens if you skip purging clams?

Preparing clams for steaming means purging live clams in salt water so they release sand, then scrubbing the shells and pulling out any that are dead. A soak of salt water with a little cornmeal gives the clams time to purge grit before they go into the pot. Clean clams steam into a broth you can eat without crunching on sand.

  • Soak live clams in salt water to purge sand, and add cornmeal to the soak if you have it.
  • Scrub the shells under cool running water right before steaming.
  • Discard clams that stay open before cooking or stay shut after steaming.
  • Clams that feel heavy and shut tight are live and ready to prepare.
  • Steam clams in a covered pot with a little liquid and pull them out as they open.

Why clams need purging before steaming

Purging clams means giving live clams time in salt water so they spit out sand and grit held in their shells. Clams filter water as they feed, so a clam pulled from the seabed can carry sand inside. Steaming does not remove that grit, and it ends up in the broth.

A salt water soak is the main step of purging clams at home, and the salt level should mimic the sea rather than taste like a strong brine. Water that is too salty stresses the clams, and fresh water kills them. The soak works because the clams stay alive and keep filtering while they sit.

A cornmeal soak is a traditional addition to the salt water, and cornmeal gives the clams something to draw in as they purge. Cornmeal does not replace the salt water soak; it sits in the same bowl. Some cooks skip the cornmeal and still get clean clams from a plain salt water soak.

Setting up the salt water soak

A salt water soak starts with a bowl or bucket big enough for the clams to sit in one layer or two. Dissolve salt in cool water until it tastes like seawater, then add the clams. Keep the bowl in a cool spot, not in direct sun.

Use about a quarter cup of salt for each gallon of water as a starting point, then taste the water. The salt should be dissolved fully before the clams go in. A spoon of cornmeal stirred through the water is the classic cornmeal soak.

Do not pile the clams deep, because clams at the bottom get less clean water moving past them. A shallow layer lets each clam purge into the water around it. Change the soak water if it turns cloudy or gritty.

How long to soak steamer clams

Soaking steamer clams for a short time is enough to loosen surface sand, and a longer soak in cool water lets more grit come out. The right length depends on how sandy the clams are and how cool the room is. Keep the clams cool while they soak, and do not leave them sitting in warm water.

Soaking clams longer than needed in water that warms up is risky, because live clams weaken in warm, stale water. A cool spot and fresh salt water protect them. If the water smells bad, dump it and start again with clean salt water.

Clams that are already clean from the fish counter may need only a short soak, while clams dug from sand need more time. Judge by the water: gritty water means the clams are still releasing sand. Repeat with fresh salt water until the water stays clear.

Sorting live clams from dead ones

Checking live clams before soaking is the first quality step, and a clam that will not shut is not a good candidate for the pot. Tap an open shell; a live clam closes in response. A shell that stays wide open and does not react should be discarded.

A live clam feels heavy for its size and holds its shell shut. A clam that feels light or rattles may be empty or full of mud. Broken shells let water in and spoil the meat, so set those aside.

Smell is a useful check on clams, and a clam that smells strongly of rot is not safe to cook. Fresh clams smell of the sea. When in doubt, throw the clam out rather than risk a bad one in the pot.

Scrubbing shells and rinsing

Scrubbing shells removes mud, algae and grit that the soak loosens but does not wash away. Work over cool running water with a stiff brush. Scrub each clam over the whole shell, paying attention to the hinge and the ridges.

Rinsing after scrubbing clears the loosened sand from the shell surface. Hold each clam under the tap and rub the shell with your fingers as the water runs. Do not let the clams sit in the dirty rinse water.

Scrubbing shells is the last step before steaming clams, and it should happen right before they go into the pot. Clams that sit after scrubbing pick up grit again in the bowl. A final rinse in clean salt water keeps them fresh until the pot is ready.

A step by step routine for preparing clams

The routine for how to prepare clams for steaming runs from sorting to soaking to scrubbing, in that order. Each step removes a different kind of dirt, and skipping one leaves grit behind. Set up the bowl before the clams arrive from the counter.

Keep the clams cool between steps, and do not let them sit in tap water. Tap water is fresh water, and fresh water kills live clams. Use salt water for every soak and plain cool water only for the quick rinse under the tap.

Plan the timing so the clams go from the last rinse into the steaming pot without a long wait. A clean bowl, a stiff brush and a covered pot are the tools you need. The work is simple once the order is clear.

  • Tap open clams and discard any that do not close.
  • Make a salt water soak that tastes like seawater and stir in cornmeal.
  • Soak the clams in a cool spot and change the water when it turns gritty.
  • Scrub each shell under cool running water with a stiff brush.
  • Rinse the clams and move them straight to the steaming pot.

Steaming clams after the soak

Steaming clams needs only a little liquid in the bottom of a covered pot, since the clams release their own salty juice as they open. A splash of water, wine or broth creates the steam. Keep the heat at a steady level so the pot does not boil dry.

Clams are done when the shells open wide, and they should come out of the pot at that moment. Overcooked clam meat turns tough and rubbery. Lift the open clams out and keep them warm while the rest finish.

Discard any clam that stays shut after a full round of steaming, because a closed shell after cooking means the clam did not open and is not safe to eat. The broth left in the pot holds the clam juice and makes a fine base for a sauce. Serve the clams with the broth and bread for dipping.

Storage and handling notes

Live clams need air and cold, so store them in a bowl covered with a damp cloth in the refrigerator. A sealed plastic bag suffocates them. Do not store clams in fresh water in the fridge.

Buy clams from a counter with clean ice and a fresh sea smell, and ask when they arrived. Clams that sit too long lose their liquor and their flavor. Transport them home in a cool bag and get them into the fridge quickly.

Handle live clams gently, because a cracked shell spoils the meat inside. A few broken shells in a bag can ruin the whole batch. Cook clams soon after purchase for the cleanest flavor and the safest result.

Questions about preparing clams for steaming

What do you soak clams in before steaming?

Clams are soaked in salt water before steaming, and the water should taste like seawater. Stir in a little cornmeal if you want the cornmeal soak method. Never soak clams in plain tap water, because fresh water kills them.

How do you prepare clams for steaming step by step?

Preparation runs from sorting to soaking to scrubbing. Tap open clams and discard those that do not close, soak the rest in salt water, then scrub each shell under cool running water. Move the clean clams straight into the covered steaming pot.

Does soaking clams in salt water get rid of sand?

Salt water soaking is what lets live clams purge sand from inside their shells. The clams keep filtering while they sit, and the grit comes out into the water. Change the water when it turns gritty and repeat until it stays clear.

Should you add cornmeal when soaking steamer clams?

Cornmeal can be added to the salt water soak, and it gives the clams something to draw in as they purge. Cornmeal is optional, and a plain salt water soak also works. Stir a spoonful through the water and let the clams sit.

How do you know a clam is alive before cooking?

A live clam holds its shell shut and feels heavy for its size. Tap an open clam and watch for it to close. Discard clams that stay open and do not react, and throw out any that smell strongly of rot.

What happens if you skip purging clams?

Skipping the purge leaves sand inside the shells, and that grit ends up in the steamed broth and on the meat. A salt water soak is the step that clears the sand. Scrubbing the shells alone does not clean the inside of the clam.

Read next

Latest articles