How to Shell a Crab

A practical guide to shelling cooked crab: removing the apron and back shell, clearing the gills, cracking claws and legs, and picking meat from the body.

7 min read8 viewsHow to Shell a Crab
— · 0 votes
Contents
  1. Start with a cooked, cooled crab
  2. Remove the apron from the underside
  3. Lift off the back shell
  4. Clear the gills and internal parts
  5. Twist off the claws and legs
  6. Crack claws and legs for the meat
  7. Pick meat from the body
  8. Keep the picked meat clean
  9. Questions About Shelling Crab
  10. Can you peel crab without cooking it first?
  11. How do you shell a crab without a nutcracker?
  12. What parts of a crab should you not eat?
  13. Is the yellow stuff inside a crab edible?
  14. How do you get meat out of thin crab legs?

Shelling a crab means separating the cooked meat from the hard shell in a set order: apron first, then back shell, gills, claws, legs and finally the body chambers. Work over a tray so the juices stay contained and the picked meat can be gathered as you go. A crab picked in this sequence gives clean flakes with little shell mixed in.

  • Cook the crab before you shell it, then let it cool enough to handle safely.
  • Remove the apron and back shell first so the gills and internal parts are exposed.
  • Scrape away the gills and any spongy tissue before you reach for the meat.
  • Twist off legs and claws, then crack each segment and push the meat out.
  • Break the body into sections and pick the channels with a thin pick or your fingers.

Start with a cooked, cooled crab

Shelling a crab begins with a crab that is already cooked, because raw crab meat clings to the shell and tears apart. Boil or steam the crab until the shell turns bright and the meat turns opaque, then lift it out to cool.

Cooling matters for your hands as much as for the meat. A crab straight from the pot is too hot to hold, so set it on a rack to drain and wait until the shell is warm rather than searing.

Set up a work surface before you begin the shelling job. A rimmed tray, a bowl for shells, a bowl for picked crab meat and a nutcracker or mallet keep the process tidy.

  • Rimmed tray to catch juices
  • Bowl for discarded shell
  • Bowl for picked crab meat
  • Nutcracker or small mallet
  • Thin pick or fork
  • Clean cloth for your hands

Remove the apron from the underside

The apron is the flap folded against the underside of the crab, and it must come off before the back shell will lift. Turn the crab belly up and locate the pointed or rounded flap at the rear.

Slip a thumb or a knife tip under the edge of the apron and lift it away from the body. Pull the flap back and tear it off in one piece, then discard it with the shell.

Removing the apron exposes the seam where the top and bottom shells meet. That seam is the entry point for the next stage of crab body and back shell removal.

Lift off the back shell

The back shell is the large dome on top of the crab, and it comes away once the apron is gone. Hold the crab in both hands and pull the top shell upward and away from the body.

Some cooked crabs release the back shell easily, while others need a little twisting at the seam. Work gently so the meat stays in the body instead of tearing away with the shell.

Set the empty back shell aside if you want to use it for serving. Otherwise, scrape any edible meat from its inside curve into your picked meat bowl and discard the shell.

Clear the gills and internal parts

Gills and apron removal is the step that makes the rest of the crab safe and pleasant to eat. The gills are the feathery gray or brown structures on either side of the body, and they are not eaten.

Scoop the gills away with your fingers or a spoon and drop them into the shell bowl. Any spongy or discolored tissue around them should come out at the same time.

The stomach sits near the front of the body and the digestive tract runs through it. Pull out the sac and any dark material you find, then rinse the exposed body briefly if it needs it.

Twist off the claws and legs

Claws and legs come off the body with a firm twist close to the joint. Hold the body steady and rotate each leg or claw until it separates, then place it on the tray.

Keep the legs and claws grouped by size so you can crack the large pieces first. The meat in the claws is a single firm lump, while leg meat runs in thinner strips.

Pulling straight out can tear the meat and leave some behind in the body. A twisting motion keeps the joint clean and makes extracting meat from shell easier later.

Crack claws and legs for the meat

A crab claw and leg shell is hard, so crack it rather than crushing it. Give the shell a firm tap with a nutcracker or the back of a knife along its length, then pull the pieces apart.

Work from the thin end toward the thick joint so the meat has somewhere to slide. Use a pick to push the meat out of narrow segments and a fork for the wider ones.

Claw meat often comes free in one piece when the shell is cracked at the knuckle. Leg meat may need the shell rolled slightly between your fingers to loosen it before it slides out.

PartToolTechnique
ClawNutcrackerCrack at the knuckle, then pull the shell apart
Large legNutcrackerTap along the length, then push meat from the thin end
Thin legRolling pinRoll gently to loosen, then squeeze the meat out
Body channelsThin pickScrape along each channel to lift the meat

Pick meat from the body

Crab meat extraction from the body means opening the chambers that remain after the gills are gone. Break the body in half along its center line, then pull the halves apart to see the internal walls.

Each chamber holds meat in thin sheets between soft partitions. Bend the body sections back and the meat lifts away more easily than it pulls out with force.

Run a pick along the channels and turn the body over to check the underside. Picking crab meat this way recovers the small flakes that would otherwise stay hidden in the shell.

Keep the picked meat clean

Harvesting crab meat goes faster when shell fragments stay out of the bowl. Pick over each handful before you add it, feeling for hard bits with your fingers.

Crab meat is delicate, so press it together only lightly as you pick. Large lumps stay whole for crab cakes and salads, while smaller flakes suit soups and stuffings.

Chill picked meat soon after shelling and use it within the time your recipe allows. Keep the meat covered so it does not dry out while you finish the remaining crab.

Questions About Shelling Crab

Can you peel crab without cooking it first?

No, crab is shelled after cooking because raw crab meat clings tightly to the shell and tears when pulled. Cook the crab first, then cool it until the shell is comfortable to hold before you start peeling. Can you peel crab without cooking it first?

How do you shell a crab without a nutcracker?

A crab can be shelled without a nutcracker by tapping the claws and legs with the back of a heavy knife or a small mallet. Wrap the shell in a cloth first to keep fragments from flying, and use a fork or thin pick to push the meat out.

What parts of a crab should you not eat?

The gills, the stomach sac and the apron are not eaten when you shell a crab. Remove the feathery gills and the sac near the front, and discard the apron with the shell.

Is the yellow stuff inside a crab edible?

The yellow or brown material inside a cooked crab is the hepatopancreas, and it is edible in many kitchens. Its flavor is strong, so taste a little before you mix it into picked crab meat.

How do you get meat out of thin crab legs?

Thin crab legs give up their meat when you roll the shell gently with a rolling pin or the back of a knife. Roll from the joint toward the tip, then squeeze the meat out of the opened shell.

Read next

Latest articles