How to Scale, Gut and Fillet a Fish
Learn how to scale, gut and fillet a fish step by step, from holding the descaling tool to lifting the fillet free and dealing with pin bones.
Contents
How to scale, gut and fillet a fish comes down to three clean stages done in order: scrape off the scales, open the belly and pull the guts, then cut along the backbone to lift the fillets. Working on a firm, rinsed fish with a sharp filleting knife makes each stage easier to control. This page explains each stage, the tools that suit it and how to handle the pin bones at the end.
Scale first, on a firm surface
Descaling a fish means scraping the scales off from tail toward head so they lift without tearing the skin. Work on a board or in a deep sink and hold the fish by the tail with a cloth so it does not slip. A purpose-made fish scaler or the back of a knife works, and short strokes keep fish scales from flying across the kitchen. Rinse the fish under cool water afterward to clear loose scales before the next stage.
Gut through the belly opening
Gutting a fish starts with a shallow cut from the vent up to the gills, kept shallow so the knife does not pierce the intestines. Pull the guts out with your fingers and rinse the cavity until the water runs clear. Cut around the gills and remove them with the guts if the head is staying on. Gutting is messy work on a slippery fish, so wear a glove if you are unsure of your grip, and keep the knife edge away from your guiding hand.
Fillet along the backbone
Filleting a fish means cutting down behind the head, then running the blade along the backbone to free one whole side. A thin, flexible filleting knife follows the bone better than a stiff chef knife, and long strokes keep the cut clean. Lift the fillet as you go so you can see the bone line, then repeat on the second side. Run a fingertip along the flesh afterward to find any pin bones and pull them out with tweezers or pliers.
Questions About Whole Fish Prep
Should I scale a fish before gutting it?
Yes, scale a fish before gutting it, because a whole fish is easier to hold and scrape while the body is still intact. Scaling first also keeps loose scales out of the open belly cavity. Rinse the fish between the two stages so the guts are not coated in scales. Gutting then exposes a clean cavity ready for rinsing or filleting.
Do I need a special filleting knife?
A filleting knife helps, but a thin, flexible blade of any kind can do the job if it is sharp. The flexible blade bends along the backbone and lets you feel where the bone sits. A stiff knife tends to cut too deep and waste flesh. Whichever knife you use, sharpen it before starting, since a dull edge tears fish flesh.
How do I remove pin bones from a fillet?
Pin bones come out of a fillet by feel, after you run a fingertip along the flesh and locate the small hard tips. Grip each one with tweezers or needle-nose pliers and pull at a slight angle toward the head. Pin bones sit in a line down the center of the fillet in many fish. Work slowly so the flesh around each bone stays intact.
Can I fillet a fish without gutting it first?
You can fillet a fish without gutting it, but gutting first is cleaner and keeps the fillets free of gut contents. Opening the belly and rinsing the cavity removes the parts that spoil first. A gutted fish also lies flatter and is easier to cut along the backbone. If you plan to cook the whole fish instead, gutting is still the step that readies it.