How to Fillet Fish With Bones
Learn how to fillet fish with bones: how to cut around the rib cage, how to find and pull pin bones, and which knife to use for clean boning work.
Contents
Filleting a fish with bones means cutting the flesh free while keeping the skeleton in one piece, then pulling the pin bones that stay in the fillet. The job needs a sharp fillet knife, a steady flat cut along the backbone, and a light hand around the rib cage. This page walks through the cuts in order and explains how to check the fillet for bone removal before it reaches the pan.
Setting up the fish and knife
A fillet knife with a thin, flexible blade follows the spine of the fish and keeps the cut shallow. A shorter boning knife with a stiff blade is useful close to the head and around the rib cage. Lay the fish on a board with the head toward your free hand and keep the skin dry for grip. Sharpening the blade before the first cut matters more than the type of knife.
Cutting along the backbone
The first fillet cut starts behind the head and follows the line of the spine to the tail. Hold the blade flat and let the backbone guide the edge rather than forcing a deep cut. Work in long strokes from head to tail until the flesh lifts away from the frame. The skeleton stays whole, which makes it easier to see where the bone removal work is finished.
Working around the rib cage
The rib cage sits above the belly side and stops the blade before the fillet is free. Angle the knife over the ribs and cut along their curve with short strokes. A boning knife helps here because the stiff tip lifts flesh off the ribs without tearing it. Trim the thin belly flap away from the ribs and keep it for stock or mince.
Questions About Filleting and Bones
How do you fillet a fish with bones?
Filleting a fish with bones means cutting the flesh off in one piece while the skeleton stays intact on the board. Start behind the head, run a flat blade along the spine to the tail, then lift the fillet over the rib cage. The bones that remain in the flesh come out afterward with pin bone tweezers.
What is the difference between pin bones and the rib cage?
Pin bones are fine bones set deep in the flesh along the middle of the fillet, while the rib cage is the curved frame of bones in the belly area. The rib cage stays with the skeleton when the fillet comes away cleanly. Pin bones stay in the fillet and need to be pulled before cooking.
How do you find pin bones in a fillet?
Pin bones sit in a line down the center of the fillet, tilted toward the head. Run a fingertip along the flesh against the grain to feel the tips, then grip each one with tweezers. Pull at the angle the bone lies in so it slides out without tearing the fillet.
Which knife should I use to fillet a fish?
A fillet knife with a thin, flexible blade is the tool for the long cuts along the backbone. A boning knife with a short, stiff blade suits the tight work around the rib cage and the head. Both need a sharp edge, and a whetstone keeps the blade tracking the bone instead of tearing flesh.