How to Desalt Fish

Learn how to desalt fish at home: rinse, soak, change the water and taste as you go. Covers salted cod, salt fish and fixing a batch that is still too salty.

8 min read2 views
— · 0 votes
Contents
  1. Start by rinsing and cleaning the fish
  2. Soak salt fish in cold water
  3. Judge the timing by thickness, not the clock
  4. Speed up desalting with smaller pieces
  5. Desalt salted cod for bacalao dishes
  6. Fix salt fish that is still too salty
  7. Store and cook desalted fish safely
  8. Questions About Desalting Salt Fish
  9. How do you desalt salted fish quickly?
  10. How long does salt cod need to soak?
  11. Can you remove too much salt from salted fish?
  12. Should you soak salt fish in warm water?
  13. Do you need to clean salted cod before soaking?
  14. What can you do if salt fish is still too salty after soaking?

Desalting fish means soaking salted fish in fresh water so the salt moves out of the flesh and into the water. You rinse the surface first, then soak the fish in cold water and change that water several times until the flesh tastes right. The method is simple, but the timing depends on the thickness of the fish and on how much salt it carries.

  • Rinse the fish under cold running water before soaking to remove loose salt and surface grit.
  • Soak in cold water, keep the fish cold, and change the water several times during the process.
  • Slice thick pieces or cut them smaller so the salt leaves the flesh at a more even rate.
  • Taste a small piece as you go; the fish is ready when it tastes seasoned rather than sharp.
  • If the fish turns out too salty after soaking, soak it again in fresh water before cooking.

Start by rinsing and cleaning the fish

Cleaning salted fish is the first step of desalting, and a cold water rinse does most of the work. Run the fish under cold running water to wash away loose salt, dried brine and any grit on the surface. Rinse both sides and the cut edges, where salt collects in a crust.

Look over the fish while you rinse it and remove anything that does not belong in the pan. Scrape or pull away dry patches of salt and any tough bits at the edges. If the fish is very dry and stiff, a short rinse softens the surface enough to inspect it.

Cleaning salted cod also means checking the skin and any remaining fins or scales. Trim these away with a knife or kitchen scissors before soaking, since they add nothing to the finished dish. Pat the rinsed fish dry only if you plan to cut it into smaller pieces.

Soak salt fish in cold water

Soaking salted fish in water is the core of desalting, and cold water does the job without cooking the flesh. Place the fish in a bowl or container and cover it completely with cold fresh water. Keep the container in the refrigerator while the fish soaks.

The water pulls salt out of the flesh, so replacing it matters more than stirring. Pour off the old water and add fresh cold water several times during the soak. Each change of water carries away salt and speeds the process along.

Keep the fish fully submerged, because any part above the water line stays salty. A plate set on top of the fish holds it under the surface. Soaking salted fish in water with a lid also keeps refrigerator odors away from other food.

Judge the timing by thickness, not the clock

How long to desalt cod depends on the thickness of the pieces and how heavily the fish was salted. Thin fillets and small strips give up salt faster than thick center cuts. A thick piece needs more water changes and more time in the bowl.

Treat the timing as a guide rather than a rule, and check the fish as it soaks. Cut a small piece from the thickest part and taste it after a few water changes. The flesh should taste pleasantly seasoned, not sharply salty.

Cooler water slows the movement of salt, so a cold refrigerator soak takes longer than a soak in a warm room. Never leave salted fish sitting out at room temperature for long, because bacteria grow quickly on wet fish.

Cut of fishSoak approachWhat to check
Thin fillet or stripFewer water changes, shorter soakTaste after the first or second change
Thick center cutMore water changes, longer soakTaste the middle of the thickest part
Whole dried pieceSoak whole, then cut and soak againTaste a piece from the center
Very dry, stiff fishLonger first rinse, then soakCheck that the flesh softens evenly

Speed up desalting with smaller pieces

If you want to desalt salt fish quickly in water, cut the fish into smaller pieces before soaking. More surface area means salt leaves the flesh faster and the water reaches the center sooner. Slices and cubes desalt in less time than a whole thick fillet.

Place the cut pieces in a wide container so they sit in a single layer where possible. Cover them with cold water and change the water more often when the pieces are small. Thin slices give up salt fast, so taste them early to avoid oversoaking.

Warm water draws salt out faster, but it also softens the flesh and encourages bacterial growth. Cold water with frequent changes is the safer way to speed up the process. Keep the fish refrigerated throughout, even when you change the water often.

Desalt salted cod for bacalao dishes

Desalting salt cod, the fish known as bacalao in some kitchens, follows the same soak and rinse method. Salt cod is usually sold as thick dried fillets or whole pieces, so it needs a longer soak than thin salt fish. Rinse the surface, then soak the cod in cold water and change the water repeatedly.

Salt cod preparation often begins with cutting the fillet into portions that fit your recipe. Smaller portions desalt faster and let you check the seasoning in each piece. Keep the skin on if your recipe calls for it, and remove it after soaking if you prefer.

A finished piece of desalted cod should taste like seasoned fish rather than salt. Taste a flake from the thickest section before you cook it. If the middle still tastes sharp, give it another soak in fresh water.

Fix salt fish that is still too salty

When salt fish is too salty after soaking, the fix is more fresh water and more time. Return the fish to a clean bowl, cover it with cold water and change the water again after a while. Taste a small piece before you decide it is ready.

Salt cod that is too salty often has a thick center that soaked less than the edges. Cut the thick parts smaller so the water can reach them. A second soak in fresh cold water pulls out the remaining salt without damaging the flesh.

If the fish is already cooked and tastes too salty, add it to a dish with unsalted ingredients such as potatoes, rice or vegetables. These ingredients absorb some of the salt and balance the plate. Avoid adding more salt to the recipe until you have tasted the finished dish.

Store and cook desalted fish safely

Desalted fish is a perishable product and belongs in the refrigerator until you cook it. Keep it covered in cold water or wrap it well and use it soon after soaking. Do not leave soaked fish on the counter for long periods.

When you are ready to cook, drain the fish and pat it dry with paper towels. Dry fish browns better in a hot pan and holds its shape in stews. Discard the soaking water, which holds the salt you removed.

Cook desalted fish thoroughly, since salted fish is a raw product until it is heated through. Use it in dishes that suit its firm texture, such as stews, gratins and fried cakes. Taste the dish before adding salt, because the fish still carries some seasoning.

Questions About Desalting Salt Fish

How do you desalt salted fish quickly?

Desalting salted fish quickly means cutting it into smaller pieces and changing the water often. Small pieces give up salt faster, and frequent water changes carry the salt away. Keep the fish cold the whole time and taste it early so it does not oversoak.

How long does salt cod need to soak?

Salt cod soaking time depends on the thickness of the piece and how heavily it was salted. Thin pieces need fewer water changes, while thick center cuts need more. Taste the thickest part to judge when the fish is ready.

Can you remove too much salt from salted fish?

Yes, salted fish can lose too much salt if it soaks too long in fresh water. Oversoaked fish tastes flat and turns soft, so taste it as you go. Stop soaking once the flesh tastes seasoned rather than sharp.

Should you soak salt fish in warm water?

Warm water pulls salt out faster, but it softens the flesh and encourages bacteria to grow. Cold water with frequent changes is the safer choice for desalting. Keep the fish refrigerated during the entire soak.

Do you need to clean salted cod before soaking?

Yes, cleaning salted cod before soaking removes loose salt, grit and dry patches from the surface. Rinse the fish under cold running water and trim away fins, scales and tough edges. A clean surface helps the soak work evenly.

What can you do if salt fish is still too salty after soaking?

If salt fish is still too salty, soak it again in fresh cold water and change the water once more. Cut thick parts smaller so the water reaches the center. In a cooked dish, pair the fish with unsalted potatoes, rice or vegetables to balance the taste.

Read next

Latest articles