# How to Clean Fish Before Cooking

A practical guide to cleaning fish before cooking: scaling, gutting, rinsing, checking fillets, and handling frozen, small, and skinless fish safely.

Cleaning fish before cooking means removing scales, guts, gills, and surface grit so the flesh is ready for the pan. Whole fish and fillets take different routes: a whole fish needs scaling and gutting, while a fillet needs a rinse, a pat dry, and a check for stray bones and skin. Working on a cold, clean surface and keeping your hands and tools washed between steps protects both the fish and the cook. The sections below set out the steps for each case, including frozen fillets, small fish, and a vinegar rinse. 

## Scaling and gutting a whole fish 

Scaling and gutting a whole fish starts with a firm grip and a cutting board that will not slide. Hold the fish by the tail and scrape the scales off with a fish scaler or the back of a knife, working from tail to head against the grain and rinsing the board as scales build up. Cut a shallow slit from the vent to the gills, pull out the guts, and scrape the dark line along the backbone until it is clean. Cut out the gills with scissors or a knife, then rinse the cavity until the water runs clear. 

## Rinsing and drying fillets 

A fish fillet is cleaned by a short rinse under cold running water, not a long soak. Run your fingers over the surface to feel for pin bones and pull any loose ones with tweezers or pliers. Pat the fillet dry with paper towels so the surface is not wet when it meets the heat. A rinse with vinegar diluted in cold water can help lift surface slime and odor from a fillet, but keep the contact brief and rinse again with plain water. 

## Frozen, small, and thin fish 

Frozen fish fillets are cleaned after thawing, because ice hides grit and bones and a frozen surface cannot be checked by touch. Thaw the fillet in the refrigerator, then rinse, feel for bones, and dry it as you would a fresh fillet. Small fish such as whiting are often gutted and scaled whole, and the head may be left on or removed before cooking. Deep or thick fish such as black drum need a closer look at the dark blood line, which is scraped away before the flesh is rinsed. 

## Questions about cleaning fish 

### Do you wash raw fish before cooking? 

Yes, raw fish is rinsed briefly under cold running water before cooking to remove surface grit, scales, and blood. The rinse should be short because a long soak can soften the flesh. Pat the fish dry afterward so it sears rather than steams. 

### How do you clean a tilapia or swai fillet? 

A tilapia or swai fillet is cleaned by a quick cold rinse, a check for pin bones, and a pat dry with paper towels. These farmed fillets often arrive skinless, so scaling is not needed. Look at the thin edge of the fillet for any dark fat or membrane and trim it away if you prefer. 

### How do you clean a frozen fish fillet? 

A frozen fish fillet is cleaned only after it thaws, because a hard surface hides bones and grit. Thaw it in the refrigerator, then rinse, feel for pin bones, and dry it. Do not refreeze a fillet that has been thawed and rinsed unless you plan to cook it promptly. 

### Can you clean fish with vinegar? 

Vinegar can be used as a brief rinse for fish fillets to reduce surface slime and odor. Mix a small amount of vinegar into cold water, dip the fillet quickly, then rinse with plain water and dry it. Vinegar does not make [raw fish safe to eat](/articles/is-raw-fish-safe-to-eat-handling-temperature-and-risk/) and does not replace cooking.
